Rubber Cap Carbon Filters
rubber cap carbon filters INTRODUCTION 1.HTF-CB rubber cap carbon block cartridges are manufactured using Steam Activation advance technology that complies with ASTM and JIS standard. 2.Made of high density activated carbon from Charcoal or Coconut shell base with optimize pore...
rubber cap carbon filters
1.HTF-CB rubber cap carbon block cartridges are manufactured using Steam Activation advance technology that complies with ASTM and JIS standard.
2.Made of high density activated carbon from Charcoal or Coconut shell base with optimize pore structure.Thus,giving lower pressure drop,higher efficiency and longer life span of filter.
3.Activation is carried out at 850 to 1000℃ in the pressure of steam in the rotary retort that creates finer pore structure than other.method and is ideal for absorption of liquid and vapor phase.
4.Besides standard HTF-CB,acid washed,water washed and coconut shell impregnated with silver solution are available to suit other special requirements.
Equipped with end gasket-Eliminating by passing and channeling.
Effective in removing odors,bad taste,Chlorine,certain VOSs and chemicals that deteriorate the quality of water.
No carbon media migratioin due to the use of protection inner mesh with proper sealing technique.
All materials comply with FDA and NSF standard.
Effectively remove Cryptosporidium Cysts and Giardia from the water.
Suitable for using in acid and alkaline solution up to 180℃。
Can perform particles filtration down to 1 micron.
Suitable for using in industrial,household,foods and beverages applications,etc.
Filter Media Typical Iodine No:1050(mg/gm)
Activated Carbon-Charcoal Base(CB)
Activated Carbon-Grade A Charcoal Moisture As Packed:less than 3%
Base(MAX) Chlorine Reduction:
Activated Carbon-Coconut shellbase(CBC) 10”-3800 Gallon@1GPM
Outer netting material 20”-9000 Gallon@1GPM
Inner and outer mesh 30”-13500 Gallon@1GPM
Material:Polypropylene 40”-18000 Gallon@1GPM
End Cap Material:Polypropylene
Nominal length :5,10,20,30,40&50 inches.
Outer diameter:65 or 114mm (BB)
Inner diameter:28 mm
End Configuration:DOE only
NOTE:Other size ,O.D. and I.D. available upon request
Typical Folw Rate
1.32GPM/10” Filter At 0.75 PSID
Max Operating Pressure:110 PSID Max Operating Temperature:180℉
Operating Guide: HTF-(Type)-(Micron)-(Length)-(OD)